Revision: ab issue Date: May 2011 Manual No.: 0-mag1500511



Descargar 2.78 Mb.
Página49/65
Fecha de conversión21.06.2020
Tamaño2.78 Mb.
1   ...   45   46   47   48   49   50   51   52   ...   65
3.9 Installing Wire Rolls

To select the appropriate wire refer to Section 4.3 for guidance.



  1. Open the left side panel (when facing the front of the welder)

  2. Remove the Thumbscrew Spool Lock

  3. Remove the Spring and the Spool Retainer

  4. Place the Welding Wire Spool on the Spindle.






  1. Load the wire as shown in the diagram on the following page.

  2. Once the wire is in the feed position, close the side panel and turn on the welder.

  3. Use the MIG gun trigger to advance the wire through the torch until it reaches a 1/4 to 3/8 stickout (electrode extending from the tip of the contact tube.). (See Diagram 1 on the following page)





SECTION 4:

OPERATION




Compartir con tus amigos:
1   ...   45   46   47   48   49   50   51   52   ...   65


La base de datos está protegida por derechos de autor ©odont.info 2019
enviar mensaje

    Página principal